IKEA HC-705WEN Instrukcja obsługi - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Lodówka IKEA HC-705WEN. IKEA HC-705WEN 20 stron. French door
Drukuj stronę
DAILY USE
Use of turnover beam
Please keep strictly to the warnings on the
label of the turnover beam. It is a normal
phenomenon that the surface of the turnover
beam is hot. Dews on the surface are also
normal in summer or when the surrounding
environment is wet. What you need to do is
to clean them away with cloth.
Tips: The interior temperature may require a
certain period of time to reach balance if the
setting temperature is changed or other food
is put into the refrigerator. Such a period of
time depends on the change to the setting
temperature, the surrounding temperature,
opening frequency, the amount of the stored
food and etc.
Big drawer
Pull out and install the big drawer:
A
1. Pull out the big drawer.
2. Find the hook at the left and right sides
at the drawer bottom (shown in the
figure).
3. Hold the hook at two sides with a nose
pliers or tweezers and push it up and out
of the groove of sliding rail (A), and take
out the hook at the other side with the
same method.
4. Take out the drawer.
5. Install the drawer by putting the hook
into the right place.
Note: The big drawer has a maximum load
of 10kg.
Cantilever rack
The cantilever rack could be adjusted to the
proper height as required by food. Please
adjust the cantilever rack by following the
arrows as shown in the diagram. Raise it
upward first and then take it out by tilting it
upward. During installation, put the upper
end of the fixed leg into one of the upper
slots on the supporting iron first and then
put the lower end of the fixed leg into the
third slot on the lower part of the supporting
iron.
Door-mounted bottle rack
Remove the door-mounted bottle rack by
first lifting it straight up:
12