Decofire Halo Series Instrukcje montażu, bezpieczeństwa i obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcje montażu, bezpieczeństwa i obsługi dla Grzałka Decofire Halo Series. Decofire Halo Series 17 stron. Rapid reduction area heater

Decofire Halo Series Instrukcje montażu, bezpieczeństwa i obsługi
Operation
WARNING: If the lighting instructions are not followed directly a fire or explosion may occur
resulting in property damage, personal injury or death.
• The glass flame tube may break if it is wet while in use; never use the appliance while it's raining or wet
conditions are present. Do not splash any liquid on the appliance while it is operating or hot.
• Keep children away from the unit while in use; the glass tube may be extremely hot while in use.
• Do not touch the guard while the appliance is operating or hot.
• Ensure that the heater is on a firm and level surface. The heater may be damaged if the unit tips over.
• Never use the heater if the glass tube shows any cracks.
To Light
1. Unscrew the ignition button on the burner to see if the battery has already been placed inside. If the battery is not
already within the ignition button on the burner, please place the battery into the ignition button slot.
2. Make sure the ignition control knob is turned to the 'OFF' position. Connect gas cylinder and slowly open the valve
on the gas cylinder by turning the knob counterclockwise.
3. Press in and turn the ignition control knob to the "pilot" position; hold down for 1 minute.
4. Push the ignition button, while still holding down control knob down, to generate a spark.
5. Check to see if pilot is alight through the glass tube. If there is, turn the control knob to the "low" position.
6. For maximum flame height and heat output, turn the control knob to the "high" position.
To Extinguish
1. Push and turn the ignition control knob clockwise to the 'OFF' position.
2. Turn the valve on the gas cylinder to close the gas supply and disconnect the gas cylinder.
Page 12
Operation
Observe flame height when lit.
The flame should be a yellow/blue
colour between 50 - 70cm in height.