Gandy 24H13 Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Rozrzutnik Gandy 24H13. Gandy 24H13 8 stron. 24-inch variable rate spreader
Również dla Gandy 24H13: Instrukcja obsługi (8 strony), Instrukcja obsługi (10 strony), Instrukcja montażu i części (19 strony)

5. Install braces

Turn spreader upright. Attach angle brace to hopper

ends using 1/4 x 1/2" hex bolts, securing center of

brace to top of handle with 1/4 x 1-1/4" hex bolt,

wrought washer and flange nut. NOTE: Brace has cen

ter of "U" indentation upwards. Place yellow grips on

handle, crank handle and tip of parking stand.

Place hook of spread plate chain in hole of bracket on

handle. Adjust to desired level depending on rate of

application and product weight to produce "sheet-like"

flow. If application without spread plate is desired,

swing spread plate to front of hopper and position

hook over lip of hopper.

6. Install lift handle

Attach handle to front of hopper using 1/4 x 5/8" hex

bolts and flange nuts.

Maintenance

Empty when finished; remove bottom and rotors

1. After hopper has been emptied, turn hopper over

and remove wheels.

2. Loosen wing nuts on bearing retainers.

3. Loosen the latches that secure bottom and slide to

hopper. Remove bottom.

4. Remove rotors and end bearings.

5. Wipe all parts clean.

6. Place a few drops of light oil on the end and center

bearings after each use. The bearings are oil im

pregnated and will replenish themselves to their

absorption capacity. Some materials have a fine

powder in the mixture, so it may be necessary to

oil the bearings more often to prevent the powder

from working into them.

7. Reassemble.

If necessary, remove slide from hopper bottom for

cleaning.

8. If some materials build up on the hopper bottom,

especially when atmospheric humidity is high, disas

semble the slide assembly by removing the nuts, nylon

washers and slide hanger. Wipe clean.

Reassemble slide onto hopper bottom

9. For proper slide tension when reassembling slide,

gently drive the hanger to the left until the dimple in

the slide hanger and bottom match. Secure slide hang

er with nylon washers and nuts.

Assembly Instructions