KitchenAid KECX100 Instrukcja instalacji - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Płyta grzewcza KitchenAid KECX100. KitchenAid KECX100 6 stron. Electric built-in cooktops
Drukuj stronę
SECTION D - INSTALLATING
UNIT Cont.1
Using entire length of conduit, properly connect power supply leads from the unit to the junction box. DO NOT CUT
CONDUIT
WARNING:
IMPROPER
CONNECTION
OF WIRES MAY DAMAGE COOKTOP.
IF JOINING
TO ALUMINUM
HOUSE WIRING PURCHASE
CONNECTIONS
FOR JOINING
COPPER TO ALUMINUM
AND FOLLOW THE
MANUFACTURER'S
DIRECTIONS
CLOSELY.
Replace front drip bowls and insert electric elements
Grill/Griddle Models - Place drip pan and flavor generating insert in grill/griddle opening. Insert electric element. Place
either grill or griddle over element, set other aside. Place cover over grill/griddle.
Refer to Installation Checklist on front cover of this booklet.
BOLT AND CLAMP ASSEMBLY
1 After centering and aligning unit in cutout lift cooktop by placing a hand in each front element opening and engage
support rod. Place a cup washer over each bolt, grooved side away from bolt head, and put through the outermost
mounting hole in each corner of the burner box.
2. Remove unit from countertop cutout. Lock each bolt and washer in place using a flat washer and hex nut on bottom
side of burner box flange as shown in Figure 8.
3. Put burner box with attached bolts in cabinet cutout. Center and align unit in opening making sure that required
clearances are maintained.
OUTER LIP
~~-~ -
\
\
:
COUNTER
LOCKING
TUBULAR
CUP WASHER
FLAT WASHER
NUT
BURNER BOX
BOLT AND CLAMP ASSEMBLY
Figure B
4. The following work must be done below the countertop. Slide locking plate over the lower end of the bott. Hold in
place with tubular nut, making sure that locking plate is positioned to obtain maximum area possible of countertop.
See Figure B. Hand tighten tubular nut using standard slotted screwdriver.
IMPORTANT NOTE: Due to flange design hand tighten only until outerlip is snug to countertop. Over-tightening may
stress flange and cause crazing and chipping of porcelain.
Using entire length of conduit, properly connect power supply leads from the unit to the junction box. DO NOT CUT
CONDUIT
WARNING: IMPROPER CONNECTION OF WIRES MAY DAMAGE COOKTOP IF JOINING To ALUMINUM
HOUSE
WIRING PURCHASE CONNECTIONS FOR JOINING COPPER TC ALUMINUM AND FOLLOW THE MANUFACTURER'S
DIRECTIONS CLOSELY.
Replace front drip bowls and insert electric elements.
Grill/Griddle Models - Place drip pan and flavor generating insert in grill/griddle opening. Insert electric element. Place
either grill or griddle over element, set other aside. Place cover over grill/griddle.
Refer to Installation Checklist on front cover of this booklet.
-5-