IKEA 904.432.01 Podręcznik - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik dla Hob IKEA 904.432.01. IKEA 904.432.01 40 stron.
Drukuj stronę
ENGLISH
proper air circulation, as air is
needed for combustion to occur
normally.
The flow of air must not be less
than 2 m
/h per kW of installed
3
power.
The air circulation system
may take air directly from the
outside by means of a pipe with
an inner cross section of at least
100 cm
; the opening must not
2
be vulnerable to any type of
blockages.
The system can also provide
the air needed for combustion
indirectly, i.e. from adjacent rooms
fitted with air circulation tubes as
described above. However, these
rooms must not be communal
rooms, bedrooms or rooms that
may present a fire hazard.
Liquid petroleum gas sinks to
the floor as it is heavier than air.
Therefore, rooms containing LPG
cylinders must also be equipped
with vents to allow gas to escape
in the event of a leak. As a result
LPG cylinders, whether partially
or completely full, must not be
installed or stored in rooms or
storage areas that are below
ground level (cellars, etc.). It is
advisable to keep only the cylinder
being used in the room, positioned
so that it is not subject to heat
produced by external sources
(ovens, fireplaces, stoves, etc. )
which could raise the temperature
of the cylinder above 50°C.
Carry out all cabinet cutting
works before fitting the appliance
in the furniture and remove all
wood chips and sawdust.
If the appliance is Not installed
above an oven, a separator panel
(not included) must be installed
in the compartment under the
appliance.
Should you experience difficulty in
turning the burners knobs, please
contact After Sales Service for
replacement of the burner tap if
found to be faulty.
The openings used for the
ventilation and dispersion of heat
must never be covered.
GAS CONNECTION
WARNING!: Prior to
installation, ensure that the local
distribution conditions (nature of
gas and gas pressure) and the
adjustment of the appliance are
compatible.
Check that the pressure
of the gas supply is consistent
with the values indicated in
Table 1 ("Burner and nozzle
specifications").
WARNING!: The adjustment
conditions for this appliance are
stated on the label (or data plate).
WARNING!: This appliance
is not connected to a combustion
products evacuation device. It
shall be installed and connected
6