Gantner 728989 Podręcznik - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik dla Zamki Gantner 728989. Gantner 728989 4 stron. Battery powered lock

Drukuj stronę

Startup and Configuration

Power supply

The GAT Lock 6010 B is powered by a 6 V battery (see technical data).

Use the battery key to open the battery compartment of the GAT Lock

6010 B as shown below.

Right-hinged door

Inserting the battery:

1. Ensure the battery polarity is correct.

2. Press the battery down into the compartment until it locks into place.

3. Swing the battery cover back over the battery compartment.

Battery Contacts

Battery Compartment Contacts

NOTE! Insert the battery directly before the GAT Lock 6010 B is

mounted to avoid unnecessary battery usage. Only use the approved

battery listed in the "Accessories" section on page 1 (1 x Batterie 6V

Lithium 2CR5, Part No.: 125273).

Valid from February 27

, 2017 • Technical data subject to modification without notice!

DB_GAT-LOCK6010B--EN_21.indd • Part No.: 853281

Left-hinged door

Battery key

Configuration

The GAT Lock 6010 B can be configured via PC/laptop and configuration

software or by using the system data carriers included in the GAT Lock

Basic Set 6000 B USB. A detailed description of the configuration process

is available in the user manual.

For PC/laptop configuration, connect the programming cable to the jack

in the battery compartment of the GAT Lock 6010 B as shown below.

Connect the other end of the programming cable to a spare USB port on

the PC/laptop.

Communication is activated using the service data carrier. The programming

cable and service data carrier are included in the GAT Lock Basic Set

6000 B USB.

Safety Instructions

- The installation and maintenance of this device must be

performed by trained, qualified personnel.

- All applicable safety and accident prevention regulations

must be observed.

- Safety devices must not be removed.

- Please observe the technical data of the device specified in

this datasheet.

- The device must be disconnected from the power supply

prior to installation, assembly or dismantling.

PC/laptop with

configuration software

USB connector (type A)

Programming cable

Jack

Battery compartment

Battery