Century Helicopter Products Predator 70 Instrukcja obsługi - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zabawka Century Helicopter Products Predator 70. Century Helicopter Products Predator 70 20 stron.
Drukuj stronę
Black Gear - Tail Output Shaft
Counter-Clockwise Teeth
Looking down on the two tail gears notice that the black gear
has teeth that are in the opposite direction to the silver gear.
Make sure the black gear is mounted to the tail output shaft.
#HI6154 Torque Tube
Coupler & M4x5 Set
Screw
Silver
Gear
M3x4 Set Screw
Align the hole in the silver gear over the hole in the end of the
tail input shaft and secure with the M3 set screw. Slide two
M5x13 bearings and install temporarily into one half of the
gearbox (positioning the bearings) and secure the torque
coupler with M4 set screw over the flat spot using threadlock.
M3 Locknut
x 3
M3x20 Socket Screw
(middle bottom)
Insert the torque drive shaft using a little oil on the o-rings as
it is pressed into the tailboom (press towards the bearing) and
align the tailboom end to the molded key in the tail gearbox.
Close the gearbox with the M3 socket screws and locknuts.
14
#HW6075 Tail
Gear Set
Silver Gear - Tail
Input Shaft
Clockwise Teeth
#CNBB513 x 2
#HW3070A Tail
Input Shaft
#HI6078 Tail
Gearbox
M3x10 Socket
Screw
M3x15
Socket Screw
(middle top)
#CNBB511
67
#HW6074 Spacer Tube -
Tail Output Shaft
Black
Gear
M3x4 Set Screw
Align the hole in the black gear over the hole in the end of tail
output shaft and secure with the M3 set screw using locktight.
Slide the spacer tube against the gear.
69
#CNBB513
Use high performance
grease for metal gears.
Press one M5x13 bearing into the right hand side (with mount
for tail pitch lever) of the tail gearbox. Position the tail output
shaft and input shaft into the gearbox half. Adjust torque
fitting if necessary. Pack gears with quality grease.
#HI3089 Tail Pitch
71
Ball Links x 2
#HW6001
M3x15 Shoulder
Screw
#CNBB37F
x 2
M3x5 Spacer
#CNLR1003
M3x5x0.5 Micro
Washer
Slide the tail pitch slider set onto the tail output shaft and
insert the M3 shoulder screw from the bottom of the pitch
lever with the micro washer between the lever and the mount
on the gearbox and tighten in place.
Recessed hole.
68
#HW3073 Tail
Output Shaft
#HI6078 Tail
Gearbox Half
70
#HI3087A
Pitch Slider
Set
72
#CNLR1014
Short Steel
Ball
#HI6102 Tail
Pitch Lever Set