Century Helicopter Products Predator Max 90 Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zabawka Century Helicopter Products Predator Max 90. Century Helicopter Products Predator Max 90 20 stron.
Również dla Century Helicopter Products Predator Max 90: Instrukcja obsługi (20 strony)

Drukuj stronę

Century Helicopter Products Predator Max 90 Instrukcja obsługi

M3x25

Socket

Screws

#HW6115A

Rear Lower

Frames

#HW6117 Rear X Frame

Attach the X Frame to the lower side frames first using M3x8

Socket screws and locknuts at the lower hole on a flat surface.

Attach to the upper frames with M3x25 Socket screws, apply

threadlock to the holes on the upper side frames.

#HI6058K

Slipper Cap

#HI6058L

Slipper O-Ring

#HI6058J

Slipper Sleeve

Thread the slipper cap onto the sleeve until the holes align

together. Insert two M4x4 set screws at 180 degrees apart and

tighten gently. Later when the main shaft pin is attached, these

can be removed and locktighted in place.

M3x6 Flat Head

Screws x 4

Install inner gear autohub from the bottom side the inner (tail)

gear using threadlock. Attach with M3 flat head screws and

tightening evenly. Note the autohub is pre-assembled.

Standoff x 4

X-Frame

Standoff x 2

26mm Threaded Standoff

#HW6001

M4x4 Set

Screw x 2

#HI6056 Main Gear

90T - Slipper Drive

#HI6058M

Autohub - Inner

Gear CT Drive

#HI6058B

Machined Inner

Gear 70T - CT

17mm

#HW6054 Spacer

Before the main gear assembly can be inserted, make sure

that the M10x14x3.5 spacer is positioned on top of the lower

main shaft bearing. It will simply self align in the block.

Remember, do not locktight any bolts on the clutchbell or

starting shaft bearing blocks until the engine is installed.

60/70 Kit

#HI6058P

Autohub -

Slipper

#M3x8 Button

Head Screw x 4

Slide the autohub for the slipper drive from the bottom of the

main gear. Attach with M3 button head screws and tightening

evenly. Insert the slipper cap assembly, capturing the o-ring

under the cap against the autohub.

SE & Max

#HI6058N

Autohub - Outer

Gear CT Drive

#HI6058C

Machined Outer

Gear 90T - CT Drive

#HI6058D

Machined Outer

Gear 93T - CT Drive

Drive

Install outer gear autohub from the bottom side the outer main

gear using threadlock. Attach with M3 flat head screws and

tightening evenly. Overtigtening these screws could touch the

upper side frames.

#HW6001 Main

Shaft Pin & M4x4

Set Screws x 2

M3x6 Flat Head

Screws x 4