ENGLISH
Problem
Residual heat indicator does
not come on.
The symbols become hot.
There is no signal when you
touch a symbol on the con‐
trol panel.
comes on.
comes on.
and a number come on.
comes on.
If there is a fault, try to resolve it by following
the troubleshooting guidelines. If the
problem cannot be resolved, contact your
IKEA store or the After Sales Service. You can
find a full list of IKEA appointed contacts at
the end of this user manual.
Possible cause
The zone is not hot because
it operated only for a short
time.
The cookware is too large or
you put it too near to the
controls.
The signals are deactivated.
Automatic Switch Off oper‐
ates.
Child Lock or Lock operates.
There is an error in the hob.
There is an error in the hob
because a pot boiled dry. Au‐
tomatic Switch Off and the
overheating protection for
the zones operate.
If the zone operated suffi‐
ciently long to be hot, speak
to the After Sales Service.
Put large cookware on the
rear zones, if possible.
Activate the signals.
Refer to "Daily use" > "Off‐
Sound Control".
Switch off the hob and switch
it on again.
Refer to "Daily use".
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If
comes on again, speak
to an authorised installer.
Switch off the hob. Remove
the hot cookware. After ap‐
proximately 30 seconds, acti‐
vate the zone again. If the
cookware was the problem,
the error message goes out.
Residual heat indicator can
stay on. Let the cookware be‐
come sufficiently cool. Check
if your cookware is compati‐
ble with the hob.
Refer to "Cookware guid‐
ance".
If you operated the appliance
wrongly, or the installation was
not carried out by an authorised
installer, the visit from the After
Sales Service technician or dealer
may not take place free of charge,
even during the warranty period.
17
Remedy
Drukuj stronę