Century UK Neon Blaze CP V2.4G Podręcznik użytkownika - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Zabawka Century UK Neon Blaze CP V2.4G. Century UK Neon Blaze CP V2.4G 18 stron.

4. After the adjustment is finished, turn the No.10 DIP switch to "OFF" position. the regulated servo exponential parameters have been locked.

Fig. 8

The transmitter provides PIT adjustment and PIT extent adjustment and can lock the adjustment parameters as below:

1. Open the transmitter power switch when adjust, turn the No.11 DIP switch to the "ON" position, let the V1

at "0" position. Pull out the electric machine connect line. turn on the flight power, carry PIT adjustment and PIT limiting range adjustment.

2. The V1 knob on the transmitter panel rotating towards "+" end increases the PIT adjustment capacity, and rotating towards "-" end decreases

the PIT adjustment capacity.

3. The V2 knob on the transmitter panel rotating towards "+" end increases the PIT extent value, and rotating towards "-" end decreases the

PIT extent value.

4. PIT paramer adjustment in the normal flight mode: turn the flight mode switch to "N" position, regulate the knob V1 to "0" position, regulate

the knob V2 to "+10 " position, and then set the PIT parameter :

1) The PIT parameter is " +5.5° " when the throttle stick stays at the neutral position.

2) The PIT parameter is "+9° - +10° " when the throttle stick stays at the highest position.

3) The PIT parameter is "-3° - -4° " when the throttle stick stays at the lowest position.

5. PIT parameter adjustment in 3D inverted flight mode: turn the flight mode switch to "1"

position, regulate the knob V1 to "0 " position, regulate the knob V2 to "+10 " positon,

and then set the PIT parameters:

1) The PIT parameter is "0° " when the throttle stick stays at the neutral position.

2) The PIT parameter is " +9° - +10° " when the throttle stick stays at the highest position.

3) The PIT parameter is " -9°- -10° " when the throttle stick stays at the lowest position.

6. After the adjustment is finished, turn the No.11 DIP switch to "OFF" position.

the regulated PIT parameters have been locked.

Parallel

Main rotor blade

Fig. 9

PIT adjustment and locking

Vertical

9 0 °

Fig. 10

、

V2 knob on the control panel

Positive PIT

+9 ° - +1 0 °

+5 . 5°

-3 ° - -4 °

Negative PIT

Positive PIT

+9 ° - + 1 0 °

+0 °

-9 ° - - 1 0 °

Negative PIT

Flybar

Main rotor blade