IKEA DATID Podręcznik - Strona 14

Przeglądaj online lub pobierz pdf Podręcznik dla Okap wentylacyjny IKEA DATID. IKEA DATID 24 stron. 30" (76.2 cm) wall-mount canopy range hood
Również dla IKEA DATID: Podręcznik użytkownika (16 strony), Instrukcja instalacji (12 strony), Instrukcje instalacji oraz instrukcja obsługi i konserwacji (18 strony)

Drukuj stronę

ENGLISH

those parts of the appliance containing the

control knobs.

Gas connection

1. Check the "gas type" sticker attached to

the hotplate. Details of the injector sizes

used are recorded on the data plate

located on the base of the appliance.

2. This appliance shall be installed

in accordance with installation

requirements of the local gas authority

of the appropriate installation code (AS/

NZS 5601).

3. Before installing the hotplate consider

the location of the gas supply and

routing the gas line. (Refer Fig. 1).

4. For ULPG models the gas supply for the

hotplate must be regulated to a pressure

of 2.75kPa. The gas inlet connection

fitting is ½" B.S.P female thread.

5. For NG models the gas supply is

connected to a regulator which is

supplied. The inlet connection has ½"

B.S.P female thread. IT IS ESSENTIAL

THAT THE ELBOW ON THE APPLIANCE

BE HELD FIRMLY WITH A SPANNER.

DO NOT OVER TIGHTEN. The regulated

pressure for NG is 1.00kPa.

6. A manual shut-off valve must be

installed in the gas line, in an accessible

position external to the hotplate, so that

in the event of an emergency or service,

the gas supply can be shutoff.

7. For gas inlet position of appliance refer

Fig. 2 for NG and fig.3 for ULPG. After

installing the gas supply and making

all connections check thoroughly for

Fig. 1

possible leaks. Turn all control knobs

on the unit to "OFF" position. Open the

valve on the gas supply. Using a soap

and water solution check each gas

connection one at a time, by brushing

the solution over connection. Presence

of bubbles will indicate a leak. Tighten

the fitting and re-check for leaks. If it is

not possible to correct the leak, replace

fitting. Under no circumstance use

matches or flame for checking leaks.

8. Turn on appliance gas cock and light

each burner. Check for a clear blue

flame without yellow tipping. If burners

shows any abnormalties check the

following:

- Burner cap on correctly

- Burner positioned correctly

- Burner vertically aligned with injector

nipple

9. In some cases the burners will fail to

Fig. 2

Fig. 3