Ganz ZC-BT SERIES Podręcznik użytkownika - Strona 7
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Kamera bezpieczeństwa Ganz ZC-BT SERIES. Ganz ZC-BT SERIES 11 stron. Outdoor color camera
Również dla Ganz ZC-BT SERIES: Instrukcja obsługi (2 strony)
Drukuj stronęAdjusting the DIP Switch Mode (for ZC-BT series only)
●
DIP Switch is available for ZC-BT series only and each of the following
functions can be adjusted by ON/OFF of the Switch.
1
ELC/ALC
ELC Easy back focus adjustment to maximize the best
focusing (refer to Attention
ALC Factory set position
2
AGC
ON
Depending on Video signal, Gain is controlled
(Auto Gain Control)
automatically. (Factory set position)
OFF Apply in the stable light condition
3
BLC
ON
Select this position when a strong light is in the back
(Backlight
ground.
compensation)
OFF Factory set position
4
FL (Flickerless)
ON
Shutter speed to be fi xed at 1/100 (NTSC) 1/120 (PAL)
(refer to Attention
OFF (Factory set position)
* Caution: Never set to "ON" mode in ordinary locations
except for special locations like Tokyo area in Japan, etc.
The setting modes shown at left are
(= ) actual factory default settings.
1
)
2
)
EG-7
ELC Mode: This special mode is not only to help prevent focus shift but also
1
to make the lens focus adjustment easier in the fi eld of installation. Simply
make the adjustment in the following order:
- Select ELC mode
- Adjust lens focus well
- After adjusting, select ALC mode
Setting the Flickerless function to "ON" under low light conditions may
2
reduce the sensitivity.
Setting the MCB mode (for ZC-BX series only)
●
DIP Switch is available for ZC-BT series only and each of the following MCB
(Magnetic Control Bolt) is available for ZC-BX series only and it allows to
make an adjustment of ALC ELC and BLC ON/OFF without opening the
Front Cover.
AGC is always ON and FL (Flickerless) is not available in ZC-BX series.
BLC
OFF
BLC
ON mode
Magnetic Control Bolt
ELC
ON mode
ALC
ON mode