Afriso EURO-INDEX RG 210 Instrukcja obsługi - Strona 16

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kontroler Afriso EURO-INDEX RG 210. Afriso EURO-INDEX RG 210 20 stron. Level controller

Drukuj stronę
Installation and commissioning
6.3

Selecting the operating mode

1.
2.
3.
Fig. 8: Selecting the operating mode
6.4

Commissioning the device

If all prerequisites are met, the device is ready for operation.
1.
16
The grey upper part of the housing has been removed from the
black base.
Loosen the grey cover from the upper part of the housing by
means of a small screwdriver and pull the printed circuit board
out of the upper part of the housing.
Set the slide switch (2) next to the green LED to the desired po-
sition.
Reassemble the device.
Control unit and probe(s) have been installed as per chapter 6,
page 13.
Electrical connection has been completed as per chapter 6.2
page 14.
Wiring has been checked.
Desired operating mode has been selected.
Control unit housing has been closed with screws.
Switch on the power supply via the on-site mains fuse.
The connected PTC thermistor heats up.
1
Mains fuse F1
2
Slide switch for
operating modes
3
Operating mode
"Probe 1"
4
Operating mode
"Filling"
5
Operating mode
"Emptying"
RG 210