KitchenAid KICU540BSS0 Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Płyta grzewcza KitchenAid KICU540BSS0. KitchenAid KICU540BSS0 12 stron. Electric induction cooktop

Drukuj stronę

• Locate t hejunction b oxtoallow asmuch slack aspossible

between thejunction b oxandthecooktop s othatthe

cooktop c anbemoved i fservicing becomes necessary inthe

future.

• Donotcuttheconduit. Thelength o fconduit provided isfor

serviceability

ofthecooktop.

• AULlisted orCSA approved conduit connector must b e

provided ateach endofthepower s upply c able (atthe

cooktop a nd atthejunction b ox). Alisted conduit connector

isalready provided atthecooktop.

Ifthehouse h as aluminum w iring, follow theprocedure

below:

1. Connect asection o fsolid copper wire tothepigtail

leads.

2. Connect thealuminum w iring totheadded section o f

copper wire using special connectors and/or tools

designed andULlisted forjoining c opper toaluminum.

Follow theelectrical connector manufacturer's

recommended

procedure. Aluminum/copper

connection must c onform with

local c odes a ndindustry a ccepted wiring practices.

INSTALLATION INSTRUCTIONS

1. Decide on the final location for the cooktop.

NOTE: Countertop

must be 13Ad ' (3.0 cm) to 2" (5.1 cm) thick.

2. If necessary, make cutout in countertop before installing

cooktop. See "Location Requirements" section for more

information.

3. Clean cutout of any remaining dust and debris.

1. Using 2 or more people, place the cooktop upside down on a

covered surface using the foam end posts from the

packaging.

2. Insert the mounting clips (provided) into the 4 pockets along

the sides of the metallic frame under the glass top.

Excessive Weight Hazard

Use two or more people to move and install cooktop.

Failure to do so can result in back or other injury.

Using 2 or more people, place the cooktop right side up and

insert into cutout.

NOTE: Verify that the front edge of the cooktop is parallel to

the front edge of the countertop.

If repositioning

is necessary,

remove the cooktop from the cutout completely

to avoid

scratching the countertop.

Insert bottom of mounting clip into bottom of pocket

and push top over top of pocket to snap into place.