ENGLISH
Electrical connection
Prior to connecting
Check that the voltage on the rating plate
corresponds to the voltage in your home.
The rating plate is on the front edge of the
oven (visible when the door is open).
Do not remove the microwave inlet
protection plates located on the side of the
oven cavity walls. They prevent grease and
food particles from entering the microwave
inlet channels.
Ensure the oven cavity is empty before
mounting.
Ensure that the appliance is not damaged.
Check that the oven door closes firmly
against the door support and that the
internal door seal is not damaged. Empty
the oven and clean the interior with a soft,
damp cloth. Do not operate this appliance
if it has a damaged mains cord or plug, if
it is not working properly, or if it has been
damaged or dropped. Do not immerse the
mains cord or plug in water. Keep the cord
away from hot surfaces. Electrical shock, fire
or other hazards may result.
After connecting
The oven can be operated only if the oven
door is firmly closed.
Regulation require that the appliance is
earthed.
The manufacturer will accept no
responsibility for injury to persons, animals
or damage to objects arising from the
non-observance of this requirement.
The manufacturers are not liable for any
problems caused by the user's failure to
observe these instructions.
Failure to observe these instructions may
lead to risks. The Manufacturer declines any
liability for injury to persons or animals or
damage to property if these advices and
precautions are not respected.
CAUTION: The appliance is not intended to
be operated by means of an external timer
or separate remote control system.
After installation, the electrical components
must not be accessible to the user.
For installation to comply with current
safety regulations, an omnipolar switch with
minimum contact gap of 3mm is required.
WARNING : The power cable must be long
enough for connecting the appliance, once
fitted in its housing, to the main power
supply.
Do not pull the power supply cable.
If the power cable is damaged it must
be replaced with an identical one. The
power cable must only be replaced by a
qualified technician in compliance with the
manufacturer instruction and current safety
regulations. Contact an authorized service
center.
Do not operate this appliance if it has a
damaged mains cord or plug, if it is not
working properly, or if it has been damaged
or dropped. Do not immerse the mains cord
or plug in water. Keep the cord away from
hot surfaces.
Do not touch the appliance with any wet
part of the body and do not operate it when
barefoot.
For appliances with fitted plug, if the plug is
not suitable for you socket outlet, contact a
qualified technician.
Do not use extension leads, multiple sockets
or adapters. Do not connect the appliance
to a socket which can be operated by
remote control.
16
Drukuj stronę