Green Point igh Podręcznik użytkownika - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Automatyka domowa Green Point igh. Green Point igh 12 stron.

Installation

1. Verify that the operation mode is on

Disabled – 0 (Diagram 1).

2. Activate the

switch is located on the back of the sensor

behind the mounting doors. Use a thin

sharp object to move the sliding switch.

3. Install the Sensor on the base.

4. The green LED will illuminate, do a

detection test.

5. Move the operation mode to Normal - I

igh

6. The

Detection Test

It is important to perform a Walk Test after

mounting the

the sensor is properly detecting motion in the

desired areas. The Walk Test mode will indicate

whether motion is detected by an illuminated

green LED. The Walk Test mode is

automatically activated when turning on the

sensor, while the operation mode is on 0

(Disabled).

The angle of the

in order to control how far the Motion Sensor

can "see". To reduce the detection range,

simply tilt the sensor downward. To increase

igh

Sensor power. The power

Sensor is ready for activation.

igh

Sensor in order to determine if

igh

Sensor may be adjusted,