KitchenAid KD-21 SERIES Instrukcja instalacji - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Zmywarka KitchenAid KD-21 SERIES. KitchenAid KD-21 SERIES 6 stron.
Drukuj stronę5.
the wires
removed
trom
the cord
and insert
them
from
the rear of the cross channel
through
the l/2"
rounded
hole.
Tape
the wires
to the cross channel
and replace
the wiring
cover
being
careful
to avoid
pinching
the wires.
Remove
the grounding
screw
(Fig. 2) and remove
the cord
ground
wire.
Set the machine
upright.
Remove
and discard
the hose coupler
housing
(Fig.
3). Remove
the screws
that
fasten
the power
cord housing
(Fig. 3).
Remove
the rear panel
(Fig.
3) by removing
its screws.
When
removing
these screws,
remove
the four
from
each side, starting
at the bottom
and working
up, and then the top two.
c
c
.J
----wrr.
,"..
-_I "<"--.&
,
____'
"
:-.;
'_
.( I.LU%.,
.. Hose coupler
housing
-
<take
out screws to remove
-,
c
.
Power cord housing
-
remove two screws
Rear panel - start
/
with bottom
screws
when removing
Fig. 3
Fig. 4
Loosen
the two
screws
in the evaporation
channel
(Fig.
4). Remove
the two
upper
screws
from
the
front
of each side panel
(Fig.
4) loosen
the two
lower
screws
on each side panel
(Fig. 4). Loosen
the
two
screws
(Fig.
4) that
hold
each
side panel
to the
kickboard.
Remove
the two
side panels
and
tighten
the ten screws that were
loosened.
At the rear of the machine,
remove
the two
screws
(Fig.
5) that
hold
the cord
reel to the rear cross
channel.
Remove
the screw
(Fig.
6) that
holds the hose anchor
bracket
to the rear frame
member.
Cut the wire
tie (Fig. 6) that
holds the hoses to the tank.
-2-