KitchenAid KDFX 6050 Karta produktu - Strona 12

Przeglądaj online lub pobierz pdf Karta produktu dla Zmywarka KitchenAid KDFX 6050. KitchenAid KDFX 6050 16 stron.

SELECT PROGRAMME

Press the programme selection button until the required programme appears (Table 1.1, Page 5). The

appliance will switch on automatically. If required, select options (if supplied). These are saved at the end

of the cycle even if another programme is selected. The corresponding indicator lamp lights up.

WASH CYCLE

The dishwasher door must be closed and the

water tap open.

To load crockery, open the door carefully (the

Start indicator lamp will flash and a beep will

sound):

Beware of hot steam!

Press the Start button again. The programme resumes from where it was interrupted, with the door

closed.

The wash cycle can be interrupted at any time by pressing Cancel/Off button. The appliance drains

water for about 60 seconds (with the door closed) then switches off automatically.

END OF PROGRAMME

Open the door carefully only after all the lights have switched off and a beep has sounded: hot steam

may escape! Unload the appliance, starting from the lower rack in order to avoid any residual drips of

water falling onto crockery below.

For even better drying results, leave the dishwasher door open a little before unloading in order to

allow the steam to dissipate, helping the dishes to dry. The underside of the kitchen worktop must

be protected (see instructions in "Maintenance and Installation").

Changing the programme in progress/RESET

- Press the Cancel/Off button.

- Water drains automatically for up to 60 seconds with the door

closed.

- Select the programme and press the Start button.