Cequent Towing Products 30059 Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria samochodowe Cequent Towing Products 30059. Cequent Towing Products 30059 9 stron. 24k 5th wheel hitch

Drukuj stronę

Failure to follow all of these instructions may result in death or serious injury

INDEX

1. BEFORE EACH TRIP

2. HITCHING PROCEDURE

3. PULL TEST

4. UNHITCHING PROCEDURE

5. MAINTENANCE

6. HITCH INSTALLATION

7. HITCH REMOVAL

8. SEVEN YEAR LIMITED WARRANTY

GUIDELINES FOR MATCHING HITCH TRUCK AND TRAILER

If preparing to tow a 5th wheel trailer which you have not rating checked previously, please

consult Section 1 of Signature Series assembly instructions to verify proper ratings.

BEFORE EACH TRIP:

1. Lubricate skid plate surface of the hitch and pivot pin grease fitting (see Figure on cover of Manual) with automotive type

chassis grease or use a plastic lube plate to provide a lubricated surface. Use lithium grease to lubricate pivot points of

moving parts within the hitch.

2. Plastic lube plates (Towing Products No. 83001/40001) can be used to avoid messy grease. The plastic lube plate must

not exceed 3/16 of an inch in thickness to ensure hitch will operate properly. Lube plates must be 12 inches in

diameter or larger to properly distribute king pin weight.

3. Before each trip or maneuver, operate the handle and check that the jaw opens and closes freely.

4. See that all hitch pull pins (# 14, Figure 14) are in place and the spring retaining pins (#15, Figure 14) are installed(Figure 1).

Note that hitch pull pins used with the Signature Series Hitch are 90 degree bent pins and if replacements are needed, please

contact the factory. Check that all four anchor assembly handles are lynch pinned/locked through base arch shell.

Site Holes (2)

Grease Fitting

30059OP - 15MAR05D

FOR KITS 30059, 40259 & 50259

Figure 1 : Pins and Clips (Skid Plate cut away view)

PCN7735

WARNING:

Lube Skid Plate

(With No Lube Plate)

Lube Jaw

Pull Pin

Retaining

P. 2

P. 3

P. 5

P. 6

P. 7

P. 9

WARNING:

prevent

detachment

separation of hitch you must

make sure that the anchor

assemblies

installed and pinned, and

the spring retaining clip is

Clip

properly installed onto the

½" pull pin before towing.

Lynch

The spring retaining clip can

easily be seen through the

site holes in the top of the

head.

Anchor Handles overlapped

and through Arch Shell

LITHO IN USA

tilting

head

and

are

properly