Cequent Towing Products 50259 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria samochodowe Cequent Towing Products 50259. Cequent Towing Products 50259 9 stron. 24k 5th wheel hitch

Drukuj stronę

Do not attempt to hitch by using trailer jacks to lower trailer and king pin. This could result in king pin

coming to rest on top of skid plate instead of within hitch opening where jaws are located. King pin could

slide off hitch and trailer could drop, resulting in death or serious injury (see Figure 9).

•Connection for trailer wiring should be in the side of the truck bed between the driver's

seat and the wheel well for the back truck axle

•Installation of connection rearward of the wheel well may result in user placing body

between truck and trailer. WHENEVER POSSIBLE, AVOID PUTTING BODY UNDER TRAILER

OR BETWEEN TRUCK AND TRAILER!

•If you need to place any part of your body under trailer or between truck and trailer:

• All trailer tires MUST be blocked in front and behind each tire AND

• Trailer landing gear MUST be resting on firm ground AND

• Truck MUST be stationary, in park, with emergency brake on!

PULL TEST

1. With all trailer wheels still firmly blocked, and

2. Trailer landing gear still resting on firm ground and supporting trailer weight and,

3. Truck stationary and with emergency brake on:

4. Make sure no one is between truck and trailer, Return to cab of truck and release truck's emergency brake. Apply trailer

brakes. Try to pull trailer slowly forward with the truck. If the trailer is properly hitched, the wheel blocks and trailer brakes

should keep the truck from moving forward.

NOTE:

If trailer is not properly hitched, trailer will separate from hitch and truck will move forward leaving trailer behind. If

you followed all previous steps, the trailer will not drop or fall .

Failure to keep wheels blocked and landing gear down could result in trailer suddenly moving or

falling. This could result in death or serious injury!

5. After successfully performing above steps, fully raise trailer landing gear (see trailer manual).

6. Check and inspect all electrical circuits for proper operation. (Clearance lights, turn signals, stop lights, etc.).

7. Remove and store all trailer wheel blocks.

30059OP - 15MAR05D

FOR KITS 30059, 40259 & 50259

WARNING:

Failure to perform pull test may result in death or serious injury

PCN7735

WARNING:

Figure 9

WRONG

WARNING

WARNING:

LITHO IN USA