Berner ALC08 Series Instrukcja instalacji i konserwacji - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja instalacji i konserwacji dla Grzałka Berner ALC08 Series. Berner ALC08 Series 16 stron.
Drukuj stronę
- 1. Table of Contents
- 2. Uncrating
- 3. Wall Mounting
- 4. Suspended Mounting
- 5. Electrical Connections
- 6. Field Connections
- 7. Operating Instructions
- 7. Quick Start Operation
- 8. Maintenance and Cleaning
- 9. Service
- 10. Troubleshooting
- 11. Appendix
- 11. Serial Network Connection
- 11. Remote Mounted Display Faceplate
- 11. Infra-Red Remote Control
- 11. Bacnet-IP INTEGRATION
QUICK START INSTRUCTIONS
For your Berner Air Curtain with Intelliswitch™
NOTE – to navigate use up/down to select setting and left/right to change setting
Mode/Fan Speed:
Mode: Select your mode of operation (see steps on page 2)
Fan Speed: Sets the speed of the fan
Delay Time: Amount of time the air curtain is to run after the door closes
Temp Set: Amount of heat and time the air curtain is to run after the door closes
Start Time: Programmable time of day air curtain becomes active
Stop Time: Programmable time of day air curtain stops running
T-Stat Mode: Set only heat or heat & fan
Set Time/Day: Programmable clock
Locked: Unit will run as programmed but settings cannot be changed
If your air curtain unit is in "Locked" mode when you receive it:
Press and hold the left and right arrows simultaneously for 5 seconds to unlock.
www.berner.com
www.Berner.com/intelliswitch
IMPORTANT NOTE!
Berner International
Berner International
111 Progress Ave. / New Castle / PA / 16101 / USA
10
800.245.4455