decorflame M902L-42FDC Podręcznik - Strona 7

Przeglądaj online lub pobierz pdf Podręcznik dla Kominek wewnętrzny decorflame M902L-42FDC. decorflame M902L-42FDC 8 stron. Electric fireplace heater

rEPlAciNG tHE FlAME EFFEct liGHt

AND lOG-SEt liGHt BUlBS

Step 1:

Remove 12 screws on the back of fireplace and open the rear cover. There are

2 larger screws and 10 smaller screws

Step 2:

You will find 1 x 40W type B-10 bulbs under log-set bed.

Step 3:

Loosen and remove the burnt out bulb and replace with new bulb.

Step 4:

Close the rear cover. Secure the 2 larger screws into the top left corner hole

and bottom right corner holes as shown in the diagram. Secure the 10 smaller

screws into the remaining holes. Make sure the screws are in the correct holes

and have been tightened.

Step 5:

Plug in the unit.

rEPAir SEt

tOUcH-UP rEPAir PAiNt

Paint directly on the mantel unit if necessary.

rEPAirS

If any problems are found with the original parts during mantel assembly such as the

panels cannot be installed with the plastic connector. Try to solve by one of the following

methods.

Tools required: Electric drill, drill bits 3/4 inches (10 mm) or 1/16 inches (2 mm),

pencil, hammer, Phillips screwdriver, safety goggles and gloves (if necessary).

wARNING: wEAR GOGGLES BEFORE yOU START DRILLING.

OPTION 1:

Use the spare KD nuts, KD screws and plastic connector.

1. Place the plastic connector on the mantel unit and mark the drill-holes as shown in

Fig. A.

2. Drill the holes with diameter 3/4 inches (10 mm) and depth 3/4 inches (10 mm) on the

mantel. Each plastic connector needs 3 holes. See Fig. B.

Fig. B

3. Gently install the KD nuts into the drilled-holes with hammer as shown in Fig. C.

Fig. A

Fig. C