decorflame MP4100-26 Instrukcje

Przeglądaj online lub pobierz pdf Instrukcje dla Kominek wewnętrzny decorflame MP4100-26. decorflame MP4100-26 3 stron. Electric fireplace heater

Drukuj stronę

iMpOrtaNt:

NOtE: DO NOt rEtUrN UNit tO tHE StOrE

BEFOrE cONtactiNG OUr cUStOMEr

SErVicE DEpartMENt. DO NOt DiSpOSE OF

yOUr cartONS UNtil yOU arE cOMplEtEly

SatiSFiED witH yOUr NEw FirEplacE HEatEr.

plEaSE NOtE: wHEN yOU OpEN tHE cartON carEFUlly

cHEck tHE UNit aND MakE SUrE tHErE iS NO DaMaGE. iF yOU

HaVE aNy prOBlEMS witH aSSEMBliNG tHE UNit, witH HOw

tHE VariOUS FUNctiONS wOrk Or witH DaMaGE Or MiSSiNG

partS, plEaSE GO tO OUr wEBSitE www.qUalitycraFt.cOM

aND click ON cUStOMEr SUppOrt.

NOtE: the electric fireplace heater may emit a slight harmless odor when first turned on. this

is caused by activating the internal heater components for the first time and should not occur

again.

NOtE: light bulbs may become loose during shipping. if the flame effect is dim or does not

work, please check that the light bulb or bulbs are finger tight in socket. See instructions for

replacing the bulb or bulbs.

INSTRUCTION MANUAL

attENtiON:

1) Find a location for the fireplace heater that is protected from direct sunlight.

2) Do not plug the unit into the power outlet before reading all instructions.

IMPORTANT SAFETY

INSTRUCTIONS

wHEN USiNG ElEctrical appliaNcES, BaSic prEcaUtiONS SHOUlD alwayS BE

FOllOwED tO rEDUcE tHE riSk OF FirE, ElEctric SHOck, aND iNJUry tO pErSONS,

iNclUDiNG tHE FOllOwiNG:

1) read all instructions before using this electric fireplace heater.

2) this electric fireplace heater is hot when in use. to avoid burns, do not let bare skin touch

hot surfaces. the grill directly in front of the heater outlet becomes hot during heater

operation. keep combustible materials, such as furniture, pillows, bedding, papers,

clothes, and curtains at least 0.9 m (3 feet) away from the front of the unit and keep them

away from the sides and rear.

3) Extreme caution is necessary when any heater is used by or near children or individuals

with disabilities and whenever the fireplace is left operating and unattended.

4) always unplug fireplace when not in use.

ElEctric FirEplacE HEatEr

Model: MP4100-26

5) Do not operate any electric fireplace with a damaged cord or plug or after the heater

malfunctions or if it has been dropped or damaged in any manner.

6) Do not use outdoors.

7) this electric fireplace heater is not intended for use in bathrooms, laundry areas and

similar indoor locations. Never place heater where it may fall into a bathtub or other water

container.

8) Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar

coverings. arrange cord away from traffic area and where it will not be tripped over.

9) to disconnect fireplace, turn controls to off, then remove plug from outlet.

10) connect to properly grounded outlets only.

11) Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this

may cause an electric shock or fire, or damage the heater.

12) to prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on

soft surfaces, like a bed, where openings may become blocked.

13) a heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline,

paint, or flammable liquids are used or stored.

14) Use this fireplace heater only as described in this manual. any other use not

recommended by the manufacturer may cause fire, electric shock, or injury to persons.

15) avoid the use of an extension cord because the extension cord may overheat and cause

a risk of fire. However, if you have to use an extension cord, the cord shall be No.14 awG

minimum size and rated not less than 1875 watts.

16) caution: Do not plug this product into a receptacle controlled by a wall switch or dimmer.

17) when storing or transporting the unit and cord, keep in a dry place, free from excessive

vibration and store so as to avoid damage.

SAVE THESE INSTRUCTIONS

FOR FUTURE USE.

caUtiON:

iF yOU USE tHiS HEatEr iN cONJUNctiON witH a tHErMal cONtrOl, a prOGraM

cONtrOllEr, a tiMEr Or aNy OtHEr DEVicE tHat SwitcHES tHE HEatEr ON

aUtOMatically, rEMEMBEr tO OBSErVE all SaFEty warNiNGS at all tiMES. tHE

FirEplacE HEatEr HaS SaFEty OVErHEat prOtEctiON. iF tHE OVErHEat prOtEctiON

tripS, SwitcH OFF all SwitcH BUttONS aND wait apprOxiMatEly 5–10 MiNUtES. it

SHOUlD rESEt aUtOMatically ONcE tHE UNit cOOlS DOwN.

warNiNG:

prOcEDUrES aND tEcHNiqUES, iF NOt carEFUlly FOllOwED, will rESUlt iN DaMaGE tO

tHE EqUipMENt aND will ExpOSE tHE USEr tO tHE riSk OF SEriOUS iNJUry, illNESS Or

DEatH.