Ganz Thermal PT Thermal Series Skrócona instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Kamery termowizyjne Ganz Thermal PT Thermal Series. Ganz Thermal PT Thermal Series 9 stron.
Drukuj stronęPT Thermal Series Quick Start Guide
Ganz PT Thermal Top Hat
Installing the PT Thermal Camera
Ganz PT Thermal
www.ganzsecurity.com
December 2013
You will need the following items (not included) before you can install the
IP Camera (recommended tool list)
Power source: PoE Switch, 12-24V DC or 24V AC
•
IP Network
•
Ethernet Cable (STP Cat5 required)
•
Mounting bracket
•
Flat-head screwdriver
•
2 Open End Wrenches – 1 inch (25mm), OR adjustable wrenches
•
A 6-inch scale OR ruler
•
Screwdriver (if electric, set to 16 inch-pounds of torque) with a
•
T20 Torx bit
RJ-45 connecter
•
RJ-45 Crimping Tool
•
Suggested Tools for Analog Video:
•
Coax Cable
o
Coax Cable Cutter/Stripper
o
BNC Connector
o
BNC Crimping Tool
o
Prepare Cables and Gland
1.
Slide all needed cables through the bottom of the top hat.
2.
Remove electrical nut from the cable gland and place the orange
O-ring on the threaded side of the cable gland.
3.
Secure cables through the cable gland for IP66 installation by
using one of the below procedures:
Securing for IP66 (POE only)
1.
Slide the Ethernet cable through the threaded end of the cable
sealing gland, with Orange O-Ring installed.
3