Avantco 177CU110ETL Podręcznik użytkownika - Strona 8
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Urządzenia kuchenne Avantco 177CU110ETL. Avantco 177CU110ETL 12 stron. Stainless steel coffee urns
User Manual
Boil Dry Protection
Boil dry accidents are the result of boiling all the water out of an urn. These kinds of accidents
shorten component and product life in all water boiling appliances.
To prevent boil dry accidents, this appliance is equipped with a thermal limiter with an auto reset limit
on. If the water in the tank is below certain low level, the appliance will turn itself off automatically. It
takes urn up to 8 mins back to work after the temperature cools down.
To decrease the chance of boil dry accident, operators are advised to turn the appliance off
when not in use, especially overnight. Otherwise, the auto reset limit will keep urn run from
being heating to being off back and forth, therefore damaging the heating system.
Cleaning and Maintenance
1. Unplug the unit and pour out any remaining water or coffee. Allow the unit to cool.
2. After the urn has cooled, add hot water, brush the interior sides, and rinse with hot water until water
exiting the faucet runs clear.
3. Clean the filter unit and the lid with a non-abrasive detergent. Dry both components with a soft, dry
cloth.
4. The stainless steel inside and tube can be cleaned with detergent and a scouring pad.
5. The urn's tap must also be cleaned to ensure proper cleaning. If necessary, use a de-scaling agent
on the tap.
6. Clean the urn's faucet with a bottle brush. Then wash the tap with warm, soapy water and rinse.
7. Use a soft cloth to wipe the urn body dry. Do NOT use benzene, thinners, or harsh abrasives for
cleaning, as these will damage the exterior finish of the urn.
8. Always clean the coffee urn immediately after each use.
De-Scaling
1. Scale buildup can affect the urn, tap, and faucet.
2. Supermarket de-scaling agents work well, along with a variety of other techniques.
3. For a more natural approach, follow these steps.
a. Slice a lemon into four pieces, wrap them in a cloth, and place them in the urn.
b. Pour in water up to the "MAX" water level indicator.
c. Boil the water and allow the lemons to sit inside the unit for about 1 hour.
d. Pour out the water and lemons, and use a nylon brush to scrub the inside of the urn.
e. To completely remove the smell or aftertaste, refill the urn, boil the water again and dispose
of the water.
This product cannot be thrown away with other domestic waste. It requires an
authorized electronic recycling center to properly dispose of it. By recycling
this product, you help save natural resources. Make sure this product is
disposed of in a natural manner.
8
www.AvantcoEquipment.com