Avantco 178UDD4HCS Podręcznik użytkownika - Strona 16
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Urządzenia kuchenne Avantco 178UDD4HCS. Avantco 178UDD4HCS 19 stron. Beer dispensers
Również dla Avantco 178UDD4HCS: Podręcznik użytkownika (19 strony), Podręcznik użytkownika (19 strony)
Drukuj stronę
User Manual
Dispenser Trouble Shooting
Compressor is Not Running
Fuse blown or circuit breaker tripped.
Power cord unplugged.
Thermostat is at wrong temperature setting.
Cabinet in defrost cycle.
Condensing Unit Runs for Long Periods of Time
Excessive amount of warm product placed in
cabinet.
Prolonged door opening or door ajar.
Door gasket(s) not sealing properly.
Dirty condenser coil.
Evaporator coil iced over.
Cabinet Temperature is too Warm
Thermostat is at wrong temperature setting.
Airflow is blocked.
Excessive amount of warm product placed in cabinet. Allow adequate time for product to cool down.
Fuse blown or circuit breaker tripped.
Dirty condenser coil.
Prolonged door opening or door ajar.
Evaporator coil iced over.
Cabinet is Noisy
Loose parts.
Tubing vibration.
Replace fuse or reset circuit breaker.
Plug in power cord.
Dial Controls: Set to higher number.
Digital Controls: Set to lower number.
Wait for defrost cycle to finish.
Allow adequate time for product to cool down.
Ensure doors are closed when not in use.
Avoid opening doors for long periods of time.
Ensure gaskets are snapped in completely.
Remove gasket and wash with soap and water.
Check condition of gasket and replace if necessary.
Clean the condenser coil.
Unplug the unit and allow coil to defrost.
Make sure thermostat is not set too cold.
Ensure that door gasket(s) are sealing properly.
Dial Controls: Set to higher number
Digital Controls: Set to lower number
Re-arrange products to allow for proper air flow.
Make sure there is at least four inches of clearance
from the evaporator.
Replace fuse or reset circuit breaker.
Clean the condenser coil.
Ensure doors are closed when not in use.
Avoid opening doors for long periods of time.
Unplug the unit and allow coil to defrost.
Make sure thermostat is not set too cold.
Ensure that door gasket(s) are sealing properly.
Locate and tighten loose part(s).
Ensure tubing is free from contact with other tubing
or components.
- 16 -