IKEA TORSBODA Podręcznik - Strona 18
Przeglądaj online lub pobierz pdf Podręcznik dla Zmywarka IKEA TORSBODA. IKEA TORSBODA 40 stron.
Również dla IKEA TORSBODA: Podręcznik (33 strony), Podręcznik (16 strony)
Special salt
You can use special salt to soften water.
Adding special salt
If the special salt refill indicator lights up, add special salt to
the dispenser for special salt just before the programme
starts. The consumption of special salt depends on the water
hardness. The higher the water hardness, the greater the
consumption of special salt.
ATTENTION!
Detergent may damage the water softening system.
●
Only fill the dispenser of the water softening system
●
with special dishwasher salt.
Special salt for dishwashers can damage the tub due to
●
corrosion.
To make sure that any special salt that escapes is
●
washed out of the tub, add the special salt to the dis-
penser for special salt immediately before the pro-
gramme starts.
Unscrew the lid of the dispenser for special salt and re-
1.
move.
On initial start-up: Fill the dispenser right up with water.
2.
Note: Only use special salt for dishwashers.
3.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dispenser.
Fill the dispenser right up with special salt. The water in
the dispenser is displaced and forced out.
Place the lid back on the dispenser and turn to close.
4.
Rinse aid system
Rinse aid system
Rinse aid system
Rinse aid
For optimum drying results, use rinse aid.
Only use rinse aid for domestic dishwashers.
Adding rinse aid
If the rinse aid refill indicator lights up, top up with rinse aid.
Only use rinse aid for domestic dishwashers.
Switching off the water softening system
If you find the special salt refill indicator irritating, e.g. when
using combined detergents with salt replacement sub-
stances, you can switch the indicator off.
Note
To avoid damage to the appliance, only switch off the water
softening system in the following cases:
The water hardness is max. 26 °E and you are using a
●
combined detergent with salt replacement substances.
According to the manufacturers, combined detergents
with salt replacement substances can generally only be
used up to a water hardness of 26 °E without adding spe-
cial salt.
The water hardness is 0 - 8 °E. You do not need to use
●
special salt.
Press
.
1.
To open the basic settings, press
2.
seconds.
The display shows Hxx.
a
The display shows
a
Press
repeatedly until the display shows H00.
3.
To save the settings, press
4.
The water softening system is switched off and the salt re-
a
fill indicator is deactivated.
Regeneration of the water softening sys-
tem
In order to obtain fault-free function of the water softening
system, the appliance performs regeneration of the water
softening system at regular intervals.
Regeneration of the water softening system takes place be-
fore the end of the main rinse cycle in all programmes. It will
increase the run time and consumption values, e.g. water
and electricity.
Overview of consumption values with regeneration
the water softening system
Here you can find an overview of the maximum additional
running time and consumption values during regeneration
of the water softening system.
Regeneration of the water softening system
after x washing programmes
Additional running time in minutes
Additional water consumption in litres
Additional power consumption in kWh
The consumption values specified are laboratory measure-
ments determined in accordance with the currently applic-
able standard using the Eco 50° programme and with the
factory value of the water hardness set to 16 - 20 °E.
Press the catch on the lid of the dispenser for rinse aid
1.
and lift
.
for 3
.
for 3 seconds.
6
7
5
0.05
18