Bernhard Rapid Facer Podręcznik użytkownika/instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Podręcznik użytkownika/instrukcja obsługi dla Sprzęt serwisowy Bernhard Rapid Facer. Bernhard Rapid Facer 15 stron. Bedknife front facing device
Drukuj stronę
SAFETY PRECAUTION
4.2.7
To avoid trapped fingers do NOT hold the RF1000 by the magnets.
Ensure that the two magnets (part 12) are securely attached to the slide rail (part 1).
4.2.8
Ensure that the carriage end stops are secure.
Ensure that the carriage runs smoothly back and forth along the rail.
4.2.9
Ensure that the specified air supply is available. Check that the flexible hose and push in
connector are correctly assembled.
NOTE: The air supply should have an isolating valve near the Rapid Facer RF1000.
4.3
PREPARING THE RF1000 FOR WORK
SAFETY WARNING
Ensure that the power / drive to
the reel is disconnected.
To avoid pinching your fingers
do NOT hold the Rapid Facer
RF1000 by the magnets.
Carefully attach the Rapid Facer
RF1000 to the bottom of the
bedknife by the magnets. Adjust
the position of each magnet in
turn so that the disc is just clear
of the top of the cutting edge of
the bedknife at each end.
It may be necessary to slacken the locking screw (part 36) and slide the angle grinder in or
out to get the right amount of grinding disc over the bedknife. Ensure that the disc is level
with the edge of the blade and re-tighten the locking screw.
© Bernhard and Company Limited
RAPID FACER MANUAL
7