GAPOSA QCX09 Podręcznik - Strona 5
Przeglądaj online lub pobierz pdf Podręcznik dla Jednostka sterująca GAPOSA QCX09. GAPOSA QCX09 12 stron. Radio control unit for shutters and awnings
Również dla GAPOSA QCX09: Podręcznik (12 strony)
Drukuj stronę
1
2
3
4
1
2
1
2
Prog-TX (4)
Option 1
1
2
Prog-TX (4)
Programming transmitters/channels and setting the limits are made through
the buttons shown on the left. According to the type of transmitters (in the
drawing the Emitto slim line) the programming buttons (4 and 5) can be
differently placed.
UP (1)
the motor lifts the rolling shade/awning up
5
STOP (2)
the rolling shade/awning stops
DOWN (3)
the rolling shade/awning goes down
Prog-TX (4)
program the transmitter
Prog-FC (5)
set limits
3
3
DELETING A TRANSMITTER OR A CHANNEL
Using the transmitter to be deleted press and hold both Prog-TX and STOP buttons till the
motor makes a small jog
Only the transmitter used for this procedure has been deleted from motor memory
Option 2
RESET TRANSMITTER MEMORY
(DELETING ALL THE TRANSMITTERS OR CHANNELS
OR SENSORS)
Option 1
OFF
ON
Using an already programmed transmitter press and hold both Prog-TX
and STOP buttons till the motor makes first a brief jog and, after a while, a
second long jog
Memory is now empty
Option 2
1 Without an already programmed transmitter switch the motor power
2 Within 8 seconds, using any 868 Gaposa transmitter, press and hold both
Memory is now empty
Prog-TX (4)
CONNECT POWER TO THE MOTOR
ON
PROGRAMMING / ADDING A NEW
TRANSMITTER
1 Press and hold Prog-TX button on the back of
transmitter till the motor starts moving
2 Check the motor rotation then release Prog-TX
button (the motor stops)
3 Within 5 seconds, press the corresponding button
(UP if the motor turns upwards or DOWN if the motor
turns downwards)
Transmitter is now programmed
CHECKING / CHANGING DIRECTION
1 Press UP or DOWN the motor should go UP or DOWN,
otherwise to change direction:
2 Press and hold Prog-TX button on the back of
transmitter till the motor starts moving
3 Press STOP: The motor makes a brief jog
Direction of the motor has been reversed
IMPORTANT: change direction must be performed
before starting limit setting otherwise limits must
be reset
supply OFF. Then switch it ON.
Prog-TX and STOP buttons until the motor makes a long jog