Makita 1911B Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita 1911B. Makita 1911B 12 stron. Power planer
Również dla Makita 1911B: Instrukcja obsługi (16 strony), Instrukcja obsługi (13 strony), Instrukcja obsługi (18 strony), Instrukcja obsługi (12 strony)

14.

REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking t o

see that keys and adjusting wrenches are removed f r o m tool before turning

it on.

15. AVOID UNINTENTIONAL STARTING. Don't carry plugged-in tool

with finger

on switch. Be sure switch is

OFF

when plugging in.

16. OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only

extension cords intended for use outdoors and

marked.

17. STAY ALERT. Watch what you are doing, use common sense. Don't operate

tool when you are tired.

18.

CHECK DAMAGED PARTS. Before further use of the tool, a guard or other

part that is damaged should be carefully checked t o determine that it will

operate properly and perform its intended function. Check for alignment of

moving parts, binding of moving parts, breakage of parts, mounting, and any

other conditions that may affect its operation. A guard or other part that

is damaged should be properly repaired or replaced by an authorized serv-

ice center unless otherwise indicated elsewhere i n this instruction manual.

Have defective switches replaced by authorized service center. Don't use

tool if switch does not turn

on and off.

19.

GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with grounded

surfaces. For example; pipes, radiators, ranges, refrigerator enclosures.

20.

REPLACEMENT PARTS. When servicing, use only identical replacement parts.

VOLTAGE WARNIN?: Before connecting the tool t o a power source (receptacle,

outlet, etc.) be sure the voltage supplied is the same as that specified on the

nameplate of the tool. A power source w i t h voltage greater than that specified

for the tool can result in SERIOUS INJURY t o the user

as well as damage t o

the tool. If in doubt, DO NOT PLUG IN THE TOOL. Using a power source with

voltage less than the nameplate rating is harmful t o the motor.