CORNING 6780-NP Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt laboratoryjny CORNING 6780-NP. CORNING 6780-NP 10 stron. Digital microplate and orbital shakers
Również dla CORNING 6780-NP: Instrukcja obsługi (13 strony)
Drukuj stronę
Orbital Shakers (Cat. Nos. 6780-NP, 6781-NP, 6782-NP)
Electrical Requirements
120V
230V
Motor Power
Fuse
120V
230V
RPM Regulation
Shaker Orbit
Timer
Maximum Load
Dimensions (L x W x D)
Weight
Operating Conditions
NOTE: The supply cord shall be with PE conductor and cross section at least 3 x 1.0 mm
The unit can be connected to external installation with overcurrent protective device max. value 16A or 20A (USA/Canada). This device
is intended for use in a basic electromagnetic environment (Basic, class B), and it is in compliance with IEC 61326-1:2020. The device
may experience a restart during overvoltage events (surges) or voltage interruptions in mains power supply.
The Corning® LSE™ Digital Microplate and Orbital Shakers are designed to be safe when operated under the following conditions:
Indoor use
Altitude up to 2,000 meters
Pollution Degree 2
4.0 Installation
4.1 Unpacking
Before starting installation, carefully examine the shaker for damage or missing parts.
Open the box, and lift the device together with the inner packing out of the box.
Remove the inner packing and check that the shaker has not been visibly damaged during transportation. Keep the packing material
until you are sure that the shaker works properly.
Check information on the rear data label and verify the following are correct:
Model
•
Serial number
•
Electrical rating
•
Should any kind of damage have occurred during transportation, contact the carrier immediately. The carrier is responsible for
shipping damage.
4.2 Selecting the Location
Put the device on a horizontal, leveled, and stable surface.
Leave enough space around the device for normal air circulation (4 in./10 cm minimum).
Leave enough space around the device for easy access and maintenance.
Do not use the device in surroundings where there are major temperature and humidity fluctuations. Also avoid locations in direct
sunlight or places near devices that produce heat.
Avoid locations with excessive vibrations.
2
|
CORNING LSE DIGITAL MICROPLATE AND ORBITAL SHAKERS
120V ± 10%, 50/60Hz
230V ± 10%, 50Hz
15W
2 x T 1A L 250V
2 x T 0.25A L 250V
Digital, load independent, from 50 to 600 RPM in 10 RPM steps
19 mm
30 sec. to 99 min. 50 sec. in 10-second steps (under 10 min. in 1-second steps), timer HOLD function
8.8 lbs. (4 kg)
10.1 x 12.5 x 5 in. (25.6 x 31.8 x 12.7 cm)
16 lbs. (7.3 kg)
5°C to 40°C, 85% RH, non-condensing
or AWG 18 (USA/Canada).
2