CORNING 6781-NP Instrukcja obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt laboratoryjny CORNING 6781-NP. CORNING 6781-NP 13 stron. Digital microplate and orbital shakers
Drukuj stronę
CORNING
LSE
DIGITAL MICROPLATE AND ORBITAL SHAKERS
4.2. 6780-NP, 6781-NP AND 6782-NP.
The 6780-NP, 6781-NP and 6782-NP model shakers have available a variety of platforms to meet
most shaking needs. These platforms mount to the shakers via four mounting platforms which easily
plug into four rubber mount points on the top of the shaker.
5.0. OPERATING INSTRUCTIONS
5.1. INTRODUCTION
POWER
1. POWER switch – switches shaker ON (light on) or OFF.
2. RUN green signal light – lit when the shaker is running.
3. TIME yellow signal light – lit when the shaker is set on time.
4. RPM yellow signal light – lit when the shaker is set on rpm.
5. ENCODER – by rotating the encoder right (+) or left (-) you can change the set TIME or
RPM. Push the encoder to switch between TIME and RPM set values.
If you rotate the ENCODER knob quickly then values go up or down on display very
quickly.
6. START/STOP button – press to START or STOP operation.
5.2. BASIC OPERATION
POWER
Press the POWER switch on the control panel. The Corning Digital shaker automatically
detects supply frequency of 50 Hz or 60Hz, and displays F50 or F60. Then the display
switches to show the set time and illuminates the time light.
RUN
TIME
RPM
Push
Time/RPM
nx10 (RPM)
t (min)
RUN
TIME
RPM
Push
Time/RPM
nx10 (RPM)
t (min)
5
USER'S MANUAL