Makita 4131 Instrukcja obsługi - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita 4131. Makita 4131 12 stron. Metal cutter
Również dla Makita 4131: Instrukcja obsługi (12 strony), Instrukcja obsługi (14 strony), Instrukcja obsługi (12 strony), Instrukcja obsługi (12 strony)
Drukuj stronę
ENGLISH (Original instructions)
SPECIFICATIONS
Max. cutting capacity
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
DOUBLE INSULATION
Pay attention! It may become too hot.
Only for EU countries
Do not dispose of electric equipment
together
material!
In observance of European Directive
2012/19/EU on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for cutting in mild steel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The
typical
A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model
Blade diameter
-1
)
Overall length
Net weight
Safety class
with
household
equipment
environmentally
noise
level
determined
) : 89 dB(A)
pA
) : 100 dB(A)
WA
END209-4
Vibration
The
vibration
determined according to EN60745:
Work mode : cutting metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
waste
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
and
its
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
compatible
used.
Be sure to identify safety measures to protect the
•
ENE022-1
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
ENF002-2
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
ENG905-1
We
Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Metal cutter
Model No./ Type: 4131
are of series production and
2
4131
185 mm
63 mm
3,500
358 mm
5.1 kg
/II
Wear ear protection
total
value
(tri-axial
) : 2.5 m/s
h,M
2
Corporation
as
the
ENG900-1
vector
sum)
2
or less
ENG901-1
ENH101-16
responsible