CORNING OptiTect Skrócona instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Sprzęt laboratoryjny CORNING OptiTect. CORNING OptiTect 18 stron.
Drukuj stronę6 .
Opening the Cabinet
Step 1:
If the cabinet door is closed, use a 26B tool
or a 7/16-inch nut driver on the latch to open
it as shown by the inset in Figure 7. If desired
to ease work operations, follow the remaining
steps in this section to remove the exterior
door.
Step 2:
Remove nuts holding ground strap; then
remove strap. Replace nuts on studs to
prevent losing them.
Step 3:
Lift door off the hinges and set aside.
Step 4:
Reverse these steps to reinstall door after
work operations inside the cabinet are
complete.
7 .
Grounding the Cabinet
Step 1:
Unlock panel and swing it
open.
Step 2:
Open the splice chamber
door and pedestal skirt, if
equipped with these items.
Slide splice trays out.
Step 3:
Bring ground cable up
through the grommet in the
base of the splice housing
and/ or through the grommet
in the base of the cabinet
(Figure 8).
Step 4:
Attach the ground wire to the
ground bar on the wall of the
cabinet.
Step 5:
Close the splice chamber
door and/or pedestal skirt
door, if opened previously.
Step 6:
Close the panel and secure
the latch as shown in the
inset in Figure 8.
Step 7:
Attach ground wire to building ground per standard codes and local practices.
STANDARD RECOMMENDED PROCEDURE 003-873 | ISSUE 2 | APRIl 2016 | PAGE 7 OF 18
Unlock Door
Ground
Bar
Unlock Splice Chamber
with 216B Tool;
Lower Door
TPA-3696
3
Lift Door
Off Hinges
2
Remove Strap
1
TPA-3695
Figure 7 — Remove Door (Optional)
Unlock Panel
Swing Panel Open
TPA-3696
Slide Splice Trays Out
Figure 8 — Ground the Cabinet