Makita 4350CT Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita 4350CT. Makita 4350CT 13 stron. Jig saw
Również dla Makita 4350CT: Specyfikacje (2 strony), Instrukcja obsługi (13 strony), Instrukcja obsługi (13 strony), Informacje techniczne (14 strony)

Tilt the base until the desired bevel angle is obtained.

The V-notch of the gear housing indicates the bevel

angle by graduations. Then tighten the bolt firmly to

secure the base.

► 1 . Graduation 2. Bevel slot 3. Base 4. Gear housing

5. V-notch 6. Bolt

Front flush cuts

► 1 . Base 2. Bolt 3. Hex wrench

Loosen the bolt on the back of the base with the hex

wrench and slide the base all the way back. Then

tighten the bolt to secure the base.

Cutouts

Cutouts can be made with either of two methods A or B.

A) Boring a starting hole:

► 1 . Starting hole

For internal cutouts without a lead-in cut from an

edge, pre-drill a starting hole 12 mm or more in

diameter. Insert the blade into this hole to start

your cut.

B) Plunge cutting:

You need not bore a starting hole or make a

lead-in cut if you carefully do as follows.

(1)

Tilt the tool up on the front edge of the base

with the blade point positioned just above the

workpiece surface.

(2)

Apply pressure to the tool so that the front

edge of the base will not move when you

switch on the tool and gently lower the back

end of the tool slowly.

(3)

As the blade pierces the workpiece, slowly

lower the base of the tool down onto the

workpiece surface.

(4)

Complete the cut in the normal manner.

Finishing edges

To trim edges or make dimensional adjustments, run the

blade lightly along the cut edges.

Always use a suitable coolant (cutting oil) when cutting

metal. Failure to do so will cause significant blade wear.

The underside of the workpiece can be greased instead

of using a coolant.

8 ENGLISH