CORNING MRU Instrukcja montażu i instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja montażu i instalacji dla Przyrządy pomiarowe CORNING MRU. CORNING MRU 12 stron. Mid-power remote unit outdoor enclosure mimo

Drukuj stronę

INSTALL MRU IN CABINETS

Step 1:

With the cabinet still laying on backside (so door

faces upwards), open the cabinet door.

ATTENTION! Make sure that the door hatch locks into the

door rail in order to avoid closing of door while

installing the chassis. See Figure 4.

To close the door, push hatch inwards towards

the door to release.

Note: The first MRU chassis is installed on the bottom of the

cabinet and the second above it.

Step 2:

Insert one 8 mm self-tapping screw (provided

with the cabinet) halfway into the bottom hole

of each rail. Refer to Figure 5.

Note: An extension bar may be required to access the screws

due to narrow space between chassis and cabinet rails.

Step 3:

Position the bottom half slots of the MRU rack

ears onto the protruding screws and tighten the

screws using a ratchet wrench. Refer to Figure 6.

Step 4:

Insert at least two additional screws into each

of the cabinet rails to safely secure MRU and

tighten.

Step 5:

Perform Steps 2 - 4 for the second MRU,

positioning it above the first installed unit, as

shown in Figure 7.

Figure 6. Securing MRU to Cabinet Rails

Corning Optical Communications

Figure 4. Opening Cabinet Door and Locking Hatch in Place

Figure 5. Inserting Self-Tapping Screw in each Rail

Figure 7. Outdoor cabinet with

Two Installed MRUs

Quick Installation Sheet | CMA-595-AEN | Page 4