Makita 5046D Informacje techniczne - Strona 6
Przeglądaj online lub pobierz pdf Informacje techniczne dla Elektronarzędzie Makita 5046D. Makita 5046D 7 stron. Makita cordless circular saws with dust collection
Również dla Makita 5046D: Instrukcja obsługi (12 strony)
Drukuj stronę
Adjustment of lever 42
(1) Adjustment of setting position of lever 42
A. In case that the base can not move smoothly, even if the lever 42 is loosened.
Shift the setting position of lever 42 by one stage to right ( clockwise).
B. In case that the base is too loose, when the lever 42 is loosened.
Shift the setting position of lever 42 by one stage to left ( anti-clockwise).
(2) After adjustment of setting position, stop ring E-8 is assembled as follows.
* In case that the base can not move smoothly in adjusting the setting position as per (1)
Assemble stop ring E-8 when lever 42 is set at the position where movement of the base gets smooth.
* In case that the base is too loose in adjusting the setting position as per (1)
Assemble stop ring E-8 when lever 42 is set at the position before one where movement of the base
gets tight.
< 6 > Setting lead wires
(1) Adjust slit of yoke unit to rib A.
(2) After assembling yoke unit, guide lead wirs
between rib B and rib C in order to prevent
that the lead wires are pinched between ribs
and yoke unit.
(3) Armature is drawn with magnetic force
of yoke unit strongly. So, pay attention to
prevent pinching of your finger.
< 7 > Lubrication
Apply MAKITA grease No.1 in gear housing by 7 g.
Lever 42
A
Slit of yoke unit
Yoke unit
Lever 42
B
Rib C
Rib A
Rib B