CORNING FBC-005 Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Narzędzia CORNING FBC-005. CORNING FBC-005 6 stron. High precision cleaver

Drukuj stronę

Page 2

Cleaver Description

3.1 Figure 3 identifies the parts of the FBC-005 cleaver:

Rear view of cleaver

Tension adjustment switch

Fiber guide lock

fibre tensile force

Standard

+0,4 N

Left fiber guide

(reversible for

250 or 900 mm

fibers

Clamping pads*

Anvil

Figure 3

* Current production FBC-005 cleavers are equipped

with clamping pads which permit cleaving most fibers

on the market today. Cleave length is variable from

1 mm to infinity.

3.2 The following tools and materials are provided with the

FBC-005 cleaver:

• Case

• Cleaning strips

• Blade replacement tool

• Slotted screwdriver

• Lubricating oil

• Operator manual (SRP-001-055)

3.3 The following items - which are not supplied - are

required in order to complete the operating and maintenance

procedures described in this manual:

• Lint-free tissues

• Swabs

• Tweezers

• Vinyl tape

• Isopropyl alcohol

• Vertical spring (p/n 280308-01)

• Hook-type spring tool (FBC-005-07) or kit with 10

vertical springs and spring tool (FBC-005-09)

• Small punch or dowel (maximum outside diameter

of 2.8 mm [0.11 in.]

• 3 µm lapping film

SRP-001-055

Cleaver cover

Diamond

cutting

blade

Right fiber guide

FBC-005 Operation

4.1 Make a loop of vinyl tape on which to place cut pieces of

fiber. Place the loop in a convenient location.

4.2 Prepare the fiber optic cable as described in its

manufacturer's documentation.

4.3 Strip at least 5 cm (2 in) of coating from the fiber

ing to its manufacturer's instructions.

4.4 After the coating has been stripped off, clean the uncoated

fiber by wiping with a lint-free tissue soaked in alcohol. Do not

touch the cleaned fiber with your fingers.

IMPORTANT: Do not clean the fiber again after it

has been cleaved. Alcohol on the fiber ends will result in high

splice losses and quicken the deterioration of fusion splicer

electrodes.

4.5 Select the appropriate left fiber guide by pulling back on the

guide lock and rotating the reversible guide (Figure 4).

Figure 4

4.6 Pull the left fiber guide forward to its loading position

(Figure 5a).

Place the fiber in the guide to give the required cleave length.

Hold the fiber in the groove of the left fiber guide with your

index finger. Slide the guide back to its operating position (Figure

5b).The stripped fiber should extend across the anvil to the other

set of clamping pads and the right fiber guide.

Figure 5

Issue 11

accord-