CORNING OFT-000 Instalacja - Strona 4
Przeglądaj online lub pobierz pdf Instalacja dla Narzędzia CORNING OFT-000. CORNING OFT-000 4 stron. Corning cable systems optical fiber access tool
Page 4
6.2 Starting with either tool half, use a 7/64-inch hex
wrench to remove the screw closest to the first blade to be
replaced; loosen but do not remove the other screw (see
Figure 9).
6.3 Pivot the outer piece around the loosened screw so
that the blade is exposed (Figure 9). Carefully remove the
old blade and dispose of it properly.
Figure 9
6.4 Place the new blade into the tool with the ground side
of the new blade facing the piece of the tool with the
recessed area provided for the blade (see Figure 9).
Make sure that the radiused section of the blade is
fully seated against the radiused section on the tool.
Special Note:
Fiber Optic
Training
Programs
Corning Cable Systems offers comprehensive, integrated training
programs. Courses are structured for: Telephony, CATV, LAN, Intelligent
Transportation Systems and Power Utilities.
For information on Engineering Services Training call: 800-743-2671.
SRP-004-014
Radiused
areas
Ground
side
of blade
6.5 Using the corner of a flat surface, such as a counter
top or bench, press the tool down flush so that individual
parts of the tool are properly aligned (Figure 10).
Figure 10
6.6 Hold the pieces of the tool so that they fit flush along
the ends. Reinsert the screw removed in step 6.2. Tighten
both screws with the hex wrench.
6.7 Repeat steps 6.2 through 6.6 for the remainder of the
blades in the tool.
6.8 Place the two halves of the tool together. Re-thread
the thumb screw and turn it enough to secure the tool in
its open position.
6.9 Test the new blades on a scrap length of buffer tube to
verify that the tool is properly assembled. To prevent
damage to the blades, tool, or fibers, make sure that all of the
new blades are still properly seated.
Corning Cable Systems reserves the right to improve, enhance, and modify
the features and specifications of Corning Cable Systems' products without
prior notification.
Corning is a registered trademark of Corning Incorporated.
All other trademarks are the property of their respective holders
Corning Cable Systems is ISO 9001 certified.
© 2005 Corning Cable Systems.
Printed in U.S.A.
Corning Cable Systems
PO Box 489
Hickory, NC 28603-0489 USA
For US and Canada 1-800-743-2673
International
828-901-5000
FAX: 828-901-5973
http:www.corning.com/cablesystems
Issue 12
X
All rights reserved.