CORNING UAT3 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Narzędzia CORNING UAT3. CORNING UAT3 18 stron.

Initial blade depth adjustment

5.4

The top and bottom halves of the tool are identified with TOP

and BOT, respectively, near their blade depth adjustment wheels. The

blade depth adjustment assemblies are marked T for the top half of the

tool and B for the bottom half. The blade adjustment assemblies must

not be interchanged, as this may alter the actual blade depth.

To set coarse depth, adjust the tool

halves to at least 6.3 mm (0.25 in)

apart, turn the coarse wheel all the

way clockwise (in) to the bottomed

"A" setting at the index mark, and

then back out to the required setting.

This ensures that the setting is made

with the first revolution of the blade

depth adjustment.

5.5

Turn both the top and bottom FINE adjustment knobs

counterclockwise to their lowest setting, the "minus" signs (Figure 8).

Tube OD (mm)

Closure or Terminal Preparation

Prepare the closure or terminal according to the instructions supplied

with it.

IMPORTANT:

Blade Setting (Top/Bottom)

6-7

8-9

10-11

12-13

14-15

16-17

Be sure to read, understand, and follow the steps of this

section before using the tool. If the blade depths are

set too deep, damage to the fiber may result. Failure to

carefully follow these procedures may result in fiber or

ribbon damage, which in turn may lead to loss of service.

Standard Recommended Procedure 004-074 | Issue 12 | May 2017 | Page 8 of 18

Fine adjustment

wheel

Index mark and "A"

Coarse adjustment

wheel

Figure 8