Makita 5620D Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita 5620D. Makita 5620D 12 stron.

MAINTENANCE

1. Adjusting screw

2. Base

1. Triangular rule

1. Limit mark

1. Brush holder cap

2. Screwdriver

CAUTION:

•

Always be sure that the tool is switched off and the battery cartridge is

removed before attempting to perform inspection or maintenance.

Adjusting for accuracy of 90° cut (vertical cut)

001501

This adjustment has been made at the factory. But if it is off, adjust the adjust-

ing screw with a hex wrench while squaring the blade with the base using a tri-

angular rule, try square, etc.

001510

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly. Replace when they wear

down to the limit mark. Keep the carbon brushes clean and free to slip in the

holders. Both carbon brushes should be replaced at the same time. Use only

identical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out the worn carbon

001524

brushes, insert the new ones and secure the brush holder caps.

To maintain product SAFETY and RELIABILITY, repairs, any other mainte-

nance or adjustment should be performed by Makita Authorized Service Cent-

ers, always using Makita replacement parts.