Makita 6704D Instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita 6704D. Makita 6704D 8 stron. Cordless angle socket driver
Również dla Makita 6704D: Instrukcja obsługi (8 strony), Instrukcja obsługi (14 strony)
Drukuj stronę
For tool with round drive
1
2
004171
Use a bit with Form C 6.3 shank which is available on the
market. The bit can be inserted directly into the round
drive and held in place.
To install the bit, push it firmly into the round drive. To
remove the bit, grasp it with a pair of pliers and pull it out
of the round drive. Sometimes, it helps to wiggle the bit
with the pliers as you pull.
OPERATION
The proper fastening torque may differ depending upon
the kind or size of screws, the type of materials to be
fastened, the condition of the threads, etc. Before
starting your job, always perform a test operation to verify
adequate fastening torque.
Hold the tool firmly with both hands whenever possible
and place the socket over the or nut. Then turn the tool
on. As soon as the bolt or nut becomes tight, the clutch
will cut in and motor will stop automatically. Release the
switch trigger.
When fastening tool screws, use proper screwdriver bit .
It is commonly available on the market.
004183
For 6706D
When the battery capacity decreases to a certain level,
the motor will not start even if you press the switch trigger.
This mechanism prevents poor fastening caused by
battery voltage-drop. Charge the battery cartridge to
resume operation.
NOTE:
Always use the correct size socket for bolts and
•
nuts. An incorrect size will result in inaccurate and
inconsistent fastening torque and/or damage to the
bolt or nut.
1. Bit with Form C
6.3 shank
2. Round drive
7
Hold the tool with its square drive pointed straight at
•
the bolt or nut, or the bolt or nut will be damaged.
If the motor will not start even after you pull the
•
trigger, release the trigeer. Then pull the trigger
again after turning the socket slightly with your
fingers.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
ACCESSORIES
CAUTION:
These
accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Various type of Makita genuine batteries and
•
chargers
Plastic carrying case
•
or
attachments
Only use
accessory or
are