Avantes AvaLight HAL Mini Podręcznik - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik dla Sprzęt oświetleniowy Avantes AvaLight HAL Mini. Avantes AvaLight HAL Mini 18 stron.
Drukuj stronę
SMA-plug
Connect the SMA connector of the fiber to the SMA-plug of the Light Source.
I/O connector
For automatic disable control and long-life or high-power to be controlled by software it is needed
to connect an AvaSpec spectrometer to the AvaLight-HAL-Mini with the interface cable IC-DB26-2.
Now it is possible to control the output operation mode by software (AvaSoft).
The signals on the I/O connector are described below.
Pin configuration
Pin
Name
5
High
Input
power
8
Vout
Output
10
GND
11
Disable
Input
12
Long-
Input
life
Below the electrical characteristics for the input signals.
Electrical characteristics
Name
Disable
Long life
High power
Note: If high-power and long-life are both high, the output power is not specified
2.2 12VDC Power plug
The power supply specifications are mentioned in the table below
Name
Voltage
Power
Revision: 1-01
© Avantes BV
Description
Input, used to increase the power output with 10% (reduced life
time of the bulb)
Nominal 12VDC output (minimum 10.8V, maximum 13.2V)
Ground
Input, used to disable/shut down the output
Input, used to decrease the power output with 10% (increased life
time of the bulb)
Low level detection
< 1.0V
< 1.0V
< 1.0V
Minimum
10V
18Watt
www.avantes.com
High level detection
> 2.0V
> 2.0V
> 2.0V
Typical
12V
Maximum voltage
13.2V
13.2V
13.2V
Maximum
15V
5