Makita 6825 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita 6825. Makita 6825 12 stron. Drywall screwdriver
Również dla Makita 6825: Instrukcja obsługi (17 strony), Podział części (3 strony), Podział części (2 strony), Instrukcja obsługi (8 strony), Instrukcja obsługi (8 strony), Instrukcja obsługi (7 strony), Instrukcja obsługi (10 strony), Informacje techniczne (10 strony)

FUNCTIONAL

DESCRIPTION

1. Locking sleeve

1mm

1. Locator

1mm

1. Locator

1. Switch trigger

2. Lock button

CAUTION:

•

Always be sure that the tool is switched off and unplugged before

adjusting or checking function on the tool.

Depth adjustment

002612

The depth can be adjusted by turning the locking sleeve. Turn it in "A" direction

for less depth and in "B" direction for more depth. One full turn of the locking

sleeve equals 1.5 mm change in depth.

Adjust the locking sleeve so that the distance between the tip of the locator

004149

and the screw head is approximately 1 mm as shown in the figures. Drive a

trial screw into your material or a piece of duplicate material. If the depth is still

not suitable for the screw, continue adjusting until you obtain the proper depth

setting.

004154

Switch action

002628

CAUTION:

•

Before plugging in the tool, always check to see that the switch trigger

actuates properly and returns to the "OFF" position when released.

To start the tool, simply pull the switch trigger. Tool speed is increased by

increasing pressure on the switch trigger. Release the switch trigger to stop.

For continuous operation, pull the switch trigger and then push in the lock but-

ton.

To stop the tool from the locked position, pull the switch trigger fully, then

release it.

NOTE:

•

Even with the switch on and motor running, the bit will not rotate until you

fit the point of the bit in the screw head and apply forward pressure to

engage the clutch.