Makita 6825R Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita 6825R. Makita 6825R 8 stron. Drywall screwdriver
Również dla Makita 6825R: Instrukcja obsługi (8 strony), Instrukcja obsługi (7 strony), Instrukcja obsługi (12 strony)

Drukuj stronę

1mm

004154

Switch action

002628

CAUTION:

Before plugging in the tool, always check to see

•

that the switch trigger actuates properly and

returns to the "OFF" position when released.

To start the tool, simply pull the switch trigger. Tool

speed is increased by increasing pressure on the switch

trigger. Release the switch trigger to stop.

For continuous operation, pull the switch trigger and

then push in the lock button.

To stop the tool from the locked position, pull the switch

trigger fully, then release it.

NOTE:

Even with the switch on and motor running, the bit

•

will not rotate until you fit the point of the bit in the

screw head and apply forward pressure to engage

the clutch.

Reversing switch action

002635

1. Locator

1. Switch trigger

2. Lock button

1. Reversing

switch lever

CAUTION:

Always check the direction of rotation before

•

operation.

Use the reversing switch only after the tool comes

•

to a complete stop. Changing the direction of

rotation before the tool stops may damage the tool.

This tool has a reversing switch to change the direction

of rotation. Move the reversing switch lever to

the

position (A side) for clockwise rotation or

the

position (B side) for counterclockwise rotation.

Hook

002644

002645

The hook is convenient for temporarily hanging the tool.

When using the hook, pull it out in "A" direction and then

push it in "B" direction to secure in place.

When not using the hook, return it back to its initial

position by following the above procedures in reverse.

ASSEMBLY

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before carrying out any work on the

tool.

Installing or removing the bit

To remove the bit, first pull the locator out of the locking

sleeve. Then grasp the bit with a pair of pliers and pull

the bit out of the magnetic bit holder. Sometimes, it helps

to wiggle the bit with the pliers as you pull.

1. Hook