Makita 8450 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita 8450. Makita 8450 12 stron. Hammer drill

1. Action mode changing button

ASSEMBLY

1. Grip base

2. Side grip

1. Chuck key

2. Chuck

Selecting the action mode

004384

This tool has an action mode changing button.

For rotation with hammering, depress the button from the side with

fully.

For rotation only, depress the button from the side with

CAUTION:

•

Always depress the action mode changing button all the way to your

desired mode position. If you operate the tool with the button positioned

halfway between the mode symbols, the tool may be damaged.

CAUTION:

•

Always be sure that the tool is switched off and unplugged before

carrying out any work on the tool.

Installing side grip (auxiliary handle)

004198

Always use the side grip to ensure operating safety. Install the side grip on the

tool barrel. Then tighten the grip by turning clockwise at the desired position. It

may be swung 360° so as to be secured at any position.

NOTE:

The side grip cannot swing 360° when the depth gauge is installed.

Installing or removing drill bit

For Model 8450, 8452

To install the bit, place it in the chuck as far as it will go. Tighten the chuck by

002454

hand. Place the chuck key in each of the three holes and tighten clockwise. Be

sure to tighten all three chuck holes evenly.

To remove the bit, turn the chuck key counterclockwise in just one hole, then

loosen the chuck by hand.

After using the chuck key, be sure to return to the original position.

symbol

symbol fully.