Makita AF601 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita AF601. Makita AF601 13 stron. Narrow crown stapler
Również dla Makita AF601: Instrukcja obsługi i podręcznik użytkownika (13 strony)

Drukuj stronę

Use an air hose as large and as short as possible to

assure continuous, efficient nailing operation.

With an air pressure of 0.49 MPa (4.9 bar), an air hose

with an internal diameter of over 6.5 mm and a length

of less than 20 m is recommended when the interval

between each nailing is 0.5 seconds.

Air supply hoses shall have a minimum working pres-

sure rating of 1.03 MPa (10.3 bar) or 150 percent of the

maximum pressure produced in the system whichever

is higher.

Lubrication

To insure maximum performance, install an air set (oiler,

regulator, air filter) as close as possible to the tool.

Adjust the oiler so that one drop of oil will be provided

for every 50 nails.

When an air set is not used, oil the tool with pneumatic

tool oil by placing 2 (two) or 3 (three) drops into the air

fitting. This should be done before and after use.

For proper lubrication, the tool must be fired a couple of

times after pneumatic tool oil is introduced.

► 1 . Pneumatic tool oil

► 1 . Adjuster

To adjust the depth of nailing, turn the adjuster.

The depth of nailing is the deepest when the adjuster is

turned fully in the A direction shown in the figure. It will

become shallower as the adjuster is turned in the B direction.

If nails cannot be driven deep enough even when the

adjuster is turned fully in the A direction, increase the

air pressure.

If nails are driven too deep even when the adjuster is

turned fully in the B direction, decrease the air pressure.

Generally speaking, the tool service life will be longer

when the tool is used with lower air pressure and the

adjuster set to deeper depth of nail driving.

► 1 . Hook

The hook is convenient for hanging the tool temporarily.

5 ENGLISH

FUNCTIONAL

DESCRIPTION

CAUTION:

Before adjusting or checking

function on the tool, always return the trigger and

disconnect the air hose from the tool.

Adjusting depth of nailing

Hook

CAUTION:

Never hook the tool at high loca-

tion or on potentially unstable surface.

CAUTION:

Do not hang the hook from the

waist belt. If the nailer accidentally drops, it may

result in misfiring and personal injuries.