Makita AN611 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita AN611. Makita AN611 12 stron. Construction coil nailer
Również dla Makita AN611: Instrukcja obsługi (19 strony), Podział części (4 strony), Podział części (4 strony), Instrukcja obsługi (13 strony)

Drukuj stronę

1. Pneumatic tool oil

FUNCTIONAL

DESCRIPTION

1. Adjuster

ASSEMBLY

1. Door

2. Latch lever

3. Magazine cap

•

When an air set is not used, oil the tool with pneumatic tool oil by placing

005237

2 (two) or 3 (three) drops into the air fitting. This should be done before

and after use. For proper lubrication, the tool must be fired a couple of

times after pneumatic tool oil is introduced.

Adjusting depth of nailing

CAUTION:

•

Always lock the trigger and disconnect the hose before adjusting the

depth of nailing.

•

To adjust the depth of nailing, turn the adjuster so that the arrow above

005240

the adjuster will point to the number indicated on the adjuster. The depth

of nailing is the deepest when the arrow points to the number 1. It will

become shallower as the arrow points to higher number. The depth can

be changed in approx. 1.0 mm increments per graduation. If nails cannot

be driven deep enough even when the arrow points to the number 1,

increase the air pressure. If nails are driven too deep even when the

arrow points to the number 9, decrease the air pressure. Generally

speaking, the tool service life will be longer when the tool is used with

lower air pressure and the adjuster set to a lower number.

Loading nailer

CAUTION:

•

Always lock the trigger and disconnect the hose before loading the nailer.

•

Select nails suitable for your work. Depress the latch lever and open the

005241

door and magazine cap.