KitchenAid 36" Instrukcja instalacji - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Zakresy KitchenAid 36". KitchenAid 36" 16 stron. 30” and 36” gas sealed burner glass cooktops
Również dla KitchenAid 36": Instrukcje instalacji (5 strony)

Drukuj stronę

Check Operation of Oven Broil Element

1. Close the oven door.

2. Turn oven selector to BROIL. HI will appear in the

temperature display.

3. Press ENTER. Look through oven window. The top element

should glow red, and heat should be radiating out of the door.

Press CANCEL and turn oven selector to RESET.

If oven does not operate:

Check that electrical supply is connected.

Check that the circuit breaker has not tripped or the

household fuse has not blown.

Repeat start-up. If the oven still does not operate, turn off range,

turn gas shutoff valve to "closed," and contact your dealer or

authorized service company for assistance.

Install Burner Grates

Place burner grates over burner caps. The simmer plate may sit

on one of the grates or be stored for future use.

Reinstall Bottom Vent

1. Insert lower vent tabs into the slots on the front trim.

2. Push vent upward until the holes line up at top of vent.

3. Reattach the vent using the 4 screws.

A. Bottom vent

B. Reattach these screws.

Complete Installation

1. Check that all parts are now installed. If there is an extra part,

go back through the steps to see which step was skipped.

2. Dispose of/recycle all packaging materials.

3. Check that range is correctly positioned in countertop cutout

and that the range is level. See "Level Range."

4. Check that the specified distances to cabinet surfaces were

maintained. See "Location Requirements."

5. Check that burner caps are positioned properly on sealed

burner bases.

6. Check that backguard or island trim is installed. (If horizontal

clearance to combustible materials behind cooking surface is

less than 1" [2.5 cm]).

7. Check that the range is connected only to the type of gas for

which it is certified for use.

8. Use a mild solution of liquid household cleaner and warm

water to remove waxy residue caused by protective shipping

material. Dry thoroughly with a soft cloth. For more

information, see the "Range Care" section of the Use and

Care Guide.

9. Read "Range Use" in the Use and Care Guide.

10. Turn on surface burners and oven. See the Use and Care

Guide for specific instruction on range operation.

If range does not operate, check the following:

Household fuse has not blown, or circuit breaker has not

tripped.

Gas valves are turned to the "open" position.

If the gas supply line shutoff valve is open, turn to "closed"

and contact a qualified technician.

Electrical supply is connected.

See "Troubleshooting" in the Use and Care Guide.