Makita BFH040F Informacje techniczne - Strona 16

Przeglądaj online lub pobierz pdf Informacje techniczne dla Elektronarzędzie Makita BFH040F. Makita BFH040F 18 stron. Makstar 12v cordless screwdrivers

Drukuj stronę

2. After connecting flag receptacles, set Terminal in place on Housing R, and put the lead wires

(black one and red one), which connect Terminal to Motor control unit, on the lead wires from

Interlock switch unit illustrated in Fig. G.

And then apply gentle pressure to lead wires (black one and red one) in order to hold down the lead wires which

is laid under them.

Fig. G

(5) Wiring around clutch case

Put the lead wire of clutch switch unit as illustrated in Fig. H

Fig. H

Top view of clutch switch unit

Clutch switch unit

< Note >

Make sure that spacer has been mounted

to housing R, before setting terminal.

Refer to Fig. 49 in page 10.

Red lead wire which connects Terminal

to Motor control unit

And black one

Terminal

Lead holder

Clutch case

Pass the lead wires, covered by shrink tube,

through the pin.

And hold them with lead holders at clutch case.

Contain the slack portion

of lead wires and connectors

into this pace.

P 16 / 17